Raritan PX3TS Manual de usuario descargar pdf

PX 2.6.1 Build 41229

Release Notes, Revision V1 April 11, 2014

For Raritan PX3TS Customers Only Page 1

Release Notes for Raritan PX3TS Firmware Version 2.6.1

Version: PX2 2.6.1 Build 41229 Release Notes, Version 1

Date: April 11, 2014

Effective: Immediately.

Applicability:

This release contains a critical security fix found in OpenSSL (CVE-

2014-0160, details below in the Release 2.6.1 Contains All

Enhancements and Fixes section below), and it is highly recommended

that all PX3TS customers upgrade to this release immediately.

Raritan will not be liable for any security breaches resulting from

older firmware on a unit.

This firmware release is for General Availability (“GA”) on all existing

PX3TS models only. Units in the field can do a firmware upgrade to this

release.

It is NOT supported on the Raritan iPDUs (PX2-nnnn, PX3-nnnn, PXE, or

the BCM24xx).

There is a new User Guide for PX2.6.0 which should be used with this

release. Some custom engineered models may not be supported by this

release. Please check with Raritan Support if you are unsure of the model

number of your unit; it is typically viewable on the GUI Device

Information page, and is printed on a label on the unit.

Caution: Only Power IQ releases 4.1 and higher are compatible with PX2.6.1.

Due to the critical security fix, and other internal enhancements in PX 2.6.1, you

cannot downgrade from Release 2.6.1 build 41229 to ANY prior release. Please

contact Raritan Support with any questions.

Release Status: General Availability (GA) - see Release compatibility information

section below.

Release 2.6.1 contains all enhancements and fixes which are listed below:

1) The resolution for certain sensors has been increased from two (x.xx) to three

(x.xxx) decimal digits, however, accuracy is still the same as before. The

Raritan SNMP MIB contains a value that provides the resolution, and it must

be used to determine the value of sensor reading. The updated SNMP MIB

can be retrieved from the unit itself using the GUI.

1 2 3 4 5 6